Metrohm 817 Bioscan - Manual (Page 52)

3 Operation
817 Bioscan
44
Full scale The full-scale range (operating range) sets
the desired sensitivity for the analog output.
The possible values of the full-scale range
depend on the preset measuring
Range . For
RS232 data (IC Net 2.1), always the maxi-
mum settings should be used.
Offset Offset of the zero point.
Selection:
-50 ... +50 % (in steps of 10 %)
Actual
E1, E2 Display of current start and end potentials
in V.
Scan cycle Display of current scan cycle mode.
Scan rate Display of current scan rate in mV/s.
Oven Display of current oven state.
Range Display of current measuring range.
Full scale Display of current full-scale range.
Offset Display of current offset.
<Set> Sends current parameters immediately to
the 817 Bioscan. Parameters are not stored
in the system file (
*.smt ) as long as the file
is not saved.
Scan mode Operations