Metrohm 850 Professional IC Anion MSM-HC MCS Prep 1 - Manual (Page 24)

3.2 Initial installation
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
14 ￭￭￭￭￭￭￭￭
850 Professional IC – Anion MSM-HC – MCS – Prep 1
3 Connecting the eluent path
￭ Equip the 6.1834.080 eluent aspiration tubing and connect with
the eluent bottle (see Chapter 3.8.1, page 37).
￭ Connect the 6.1831.150 column inlet capillary and the capillary of
the MSM-HC labeled with Eluent with a 6.2744.040 coupling and
two 6.2744.070 short pressure screws.
￭ Use a 6.2744.090 long pressure screw to connect the capillary of
the MSM-HC labeled with Detector to the input of the MCS (see
Chapter 3.18.2, page 65).
￭ Connect the detector inlet capillary with a 6.2744.090 long pres-
sure screw to the output of the MCS (see Chapter 3.18.2, page
65).
4 Connecting the sample path
Connect the sample aspirating capillary and the sample outlet capil-
lary according to the instructions in the manual of the IC equipment
used:
￭ 6.5330.000 IC equipment for dialysis
(see manual IC equipment – 6.5330.000 – Dialysis).
￭ 6.5330.010 IC equipment for ultrafiltration
(see manual IC equipment – 6.5330.010 – Ultrafiltration).
5 Installing the peristaltic pump
(see Chapter 3.17.2, page 61).
￭ Connect the 6.1803.020 aspirating capillary for regeneration solu-
tions with a 6.2744.034 tubing olive and a 6.2744.070 short
pressure screw to the aspiration end of the 6.1826.320 pump
tubing for the regeneration solution.
￭ Place the pump tubing in a tubing cartridge.
￭ Connect the 6.1803.020 aspirating capillary for rinsing solutions
with a 6.2744.034 tubing olive and a 6.2744.070 short pressure
screw to the aspiration end of the second 6.1826.320 pump tub-
ing for the rinsing solution.
￭ Place the second pump tubing in the second tubing cartridge.
￭ Place both tubing cartridges into the peristaltic pump.
6 Connecting the MSM-HC
(see Chapter 3.16.2, page 57)
￭ Connect the capillary labeled with H2SO4 with a 6.2744.180
pump tubing connection and a 6.2744.070 short pressure screw
to the peristaltic pump on the outlet end of the pump tubing for
the regeneration solution.