Banner PresencePLUS P4 EDGE 1.3 Series - Manual (Page 104)

7.3.1 Edge Tool
The Edge tool finds and marks the position of all edges along an ROI line. It detects and counts transitions
between bright and dark pixels. The total number of edges can be counted, and the position of each edge can
be found. Edge position information can be used for distance or angle measurement.
Usage
• Measure the height and width of a part
• Count the pins on a resistor
• Measure the height of a needle
• Measure the deflection of an automotive gauge
• Detect the edge of a web
• Verify that a bottle cap is on completely
Fields
The following are fields on the Edge tool Input tab:
• Threshold Type7.2.1.2 Threshold Type on page 113
• Filters7.2.1.3 Filters on page 118
• Edge Tool Results7.3.1.4 Edge Tool Results on page 109
Supported Platforms
BCR/BCR
1.3 GEO/GEO
1.3 EDGE/EDGE
1.3 AREA/AREA1.3 OMNI/OMNI
1.3 OMNI Color ProII/ProII
1.3 ProII Color
No No Yes No Yes Yes Yes Yes
Edge Tool Input Tab
P/N 000000 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
104
7/2009 PresencePLUS Software Tools