Banner PresencePLUS P4 EDGE 1.3 Series - Manual (Page 37)

5
Tools Screen
5.1 Overview
Using the Tools screen, the user establishes the inspections that the Sensor will execute. Three
sources of inspections are available:
1. Building an inspection from scratch is the typical method of establishing an inspection. The Tools screen
is designed to aid the user in building an inspection. A typical inspection consists of Location Tools, followed
by Vision Tools, Analysis Tools, and finally (if required) the Communication Tool. The Tools screen, shown
below, supports this inspection organization.
2. Existing inspections can be obtained from the sensor (with or without the reference image) for execution
or modification. This method is very useful if the user has an existing inspection on the controller and needs
to make modifications to establish a new inspection.
3. Existing inspections also can be obtained from host resources using the Library. In this case, the sources
of the inspections are the host’s hard drive or network resources. This method provides access to an
unlimited number of existing inspections (with or without the reference image) for execution or modification.
37 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
P/N 000000