Banner PresencePLUS P4 EDGE 1.3 Series - Manual (Page 84)

6.4 Strobe Tab
Use the Strobe tab to set the strobe signal for a strobed light source. The strobe signal is a +5V dc TTL signal.
Fields in the System Setup window's Strobe tab are described below:
Strobe Tab
6.4.1 Strobe Width
P/N 000000 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
84
7/2009 System Setup Window Overview