Banner PresencePLUS P4 EDGE 1.3 Series - Manual (Page 19)

3
Getting Started
This section begins with some Vision basics, then provides a brief overview of how to install the software, and the
general steps to creating an inspection.
3.1 Installing the PresencePLUS Software
The PresencePLUS software CD includes the sensor software and this documentation.
3.1.1 Installing the Software
To install the PresencePLUS software:
1. Close all active programs.
2. Make sure that no previous installations of PresencePLUS are installed.
3. Insert the PresencePLUS CD into the CD ROM drive of the personal computer. If you have
auto-start enabled, the CD should automatically start. If it doesn't start --
a. Double-click on the My Computer icon on the desktop.
b. Double-click on the CD Drive in the list that appears.
c. Double-click on the PresencePLUS autorun file.
4. When the Install screen appears, click PresencePLUS PC Software.
5. Follow the instructions on the screen.
6. When the installation completes, reboot the PC.
3.1.2 Starting Up the Software
1. Power up the PC.
2. Install the software if it has not been installed. The installation screen of the PresencePLUS Pro
software CD is shown below.
19 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
P/N 000000