Banner SMBQS18A Mounting Bracket - Manual

SMBQS18A Mounting Bracket
For use with QS18, QS18E, and QS18AF sensors
Printed in USA 05/02 P/N 109128
Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: [email protected]
Features
• Die-cast bracket for mounting into 18 mm holes, or in combination with a swivel
bracket (such as SMB3018SC, SMB18S, or SMB18C)
• Wrap-around bracket protects sensor against damage
• Accommodates Euro-style QD connectors and cabled versions
• Cabled units tilt ±8° (if side-mounted)
• Metal hex nut, lock washer, and grommet included
• QS18AF mounts from rear (M2.5) or side (M3) using hardware included with
sensor
• Provides a low-cost alternative to an all-metal sensor
24.9 mm (0.98")
Cable
Isolation
Grommet
M2.5
for QS18AF
Models
19.4 mm (0.77")
41 mm
(1.61")
62 mm
(2.44")
Insert nut into holes in sensor
housing before inserting sensor
into bracket
QS18AF model sensor
shown; bracket also
can be used with other
QS18 models