Banner U-GAGE QT50U DC Series—Analog - Manual

SAFQT50U Mounting Flange ®
For use with QT50U sensors
Printed in USA 01/04 P/N 116804
Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: [email protected]
Features
PVC mounting flange mounts to the front of a QT50U sensor; adapts sensor to thread
into standard 2" NPT female threads.
NOTE: QT50U sensors are not designed for use in pressurized environments.
Installation
1. Place o-ring in flange groove.
2. Assemble sensor onto threaded flange as shown, using the M4 screws supplied
with the QT50U sensor.
3. Using the supplied hex wrench, torque screws to approximately 10 in/lbs.
4. Mount sensor/flange assembly into 2" NPT fitting.
ø 49.8 mm
(1.96")
49.4 mm
1.94"
25.0 mm
(0.98")
10.0 mm
(0.39")
65.0 mm
(2.56")
64.0 mm
(2.52")
2" NPT Threads
Dimensions