Banner PresencePLUS Pro—PRO Camera - Manual (Page 21)

P/N 68368 rev. B
15 01/04
Installation Manual Controller Terminal Block
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Strobe Out, Pin 4
When enabled, the system generates a strobed output signal upon the receipt of a valid trigger. The type of signal
may be configured as shown below:
Level (default: Active High)
Active High: Use if the light is enabled at 5V
Active Low: Use if the light is enabled at 0V
-------------------------------------
Strobe Width (default: Time Duration)
ON: ON continuously
OFF: OFF continuously
Exposure: Active signal during the exposure time
Time Duration: Strobe is active upon a valid trigger, with length set from 1 to 10,000 ms
-----------------------------------------
Electrical Specifications of Strobe
High: 4V min. at 100 milliamps max.
Low: 0.5V max. at 100 microamps max.
------------------------------------------
RS-232, Pin 5
The RS-232 port is used to export runtime information in ASCII format. For information on how to configure the
serial connection, see the Communication Tool and System sections in the PresencePLUS Pro Operator’s
Guide (P/N 68367)
When connecting to a PC, connect:
--------------------------------------------------------------------------
--------------------------------------------------------------------------
Pins 6–8
These pins are not used.
--------------------------------------------------------------------------
------------------------------------------
Controller Terminal Block to PC Serial Port
Pin 5 (transmit data) to Pin 2 (receive data)
Pin 2 (dc common) to Pin 5 (signal ground)