E-flite Extra 260 3D Profile - Manual (Page 15)

Important:.If.you.plan.on.using.CA.accelerator,.
make.sure.it.is.foam.compatible..Many.
accelerators.will.destroy.the.foam.used.on.this.
model.
 6. Place the motor mount in position to aid in
the alignment of the vertical and horizontal
fuselage pieces. DO NOT glue the mount until
instructed to do so. Position the horizontal and
vertical fuselage pieces until the mount rests flush
against both.
 7. Apply foam-safe CA to the joint between the
vertical and horizontal fuselage pieces from
the leading edge of the wing to the front of the
fuselage. Use a square to make sure the two
pieces are aligned. Apply CA to both the top and
bottom of the vertical fuselage.
15