E-flite Extra 260 3D Profile - Manual (Page 24)

 4. Slide a micro control connector into the hole
drilled in the previous step. Secure the connector
using a control connector backplate from the
opposite side of the connector. Repeat for all four
servo arms.
Note:.The.connectors.will.face.out.away.from.
the.servo.when.installed..Remove.any.unused.
sides.or.portions.of.the.servo.arms.
 5. Plug the servos into the receiver. Turn on the
transmitter and receiver and check the operation
of the servos. After centering the trims and sub-
trims, attach the servo arms as shown. Note the
direction of the arms on the servos creates two
pairs of servos: one for ailerons, and one for
rudder/elevator.
4