E-flite Extra 260 3D Profile - Manual (Page 31)

 6. Use foam-safe CA to glue the plywood mount to
the fuselage. Make sure the mount is pressed fully
against the fuselage, with each carbon support in
each slot, to make sure it is aligned properly.
Note:.Steps.7.and.8.cover.the.installation.of.the.
servo.and.linkage.for.a.variable.pitch.propeller..
Skip.to.Step.9.if.you.are.not.using.a.variable.
pitch.propeller.
Note:.Be.sure.to.consult.the.manual.for.
your.chosen.variable.pitch.prop.unit.before.
proceeding.with.installation.of.the.pitch.servo.
and.linkage..Due.to.the.variety.of.VPP.systems.
available,.there.may.be.some.variation.in.how.
the.servo.and.linkage.can.be.installed.
 7. Check that the linkage for your variable pitch
prop unit can move freely without binding on the
fuselage. Trim away any material necessary if any
binding is noticed.
31