HCO MB600 User Manual
Page 19
Page | 18
Note 2: Once the Send Mode is changed to OFF, the module will be turned off and will
not receive any further text message commands; you will need to retrieve the camera to
turn cellular mode back ON.
Additional text message commands supported are:
User can send text message commands to change the remote control modes as shown
in the above table. HHMM means the wake up time for Once mode. For instance,
#RT11130# means change the remote control mode to once a day and the Receive Time
is 11:30am.
Note: once the remote control is disabled, the camera will not accept any further text
message commands.
User can send text message commands to change the Time Lapse setting. NNN stands
for interval time here, which is in unit of minute. Only 001 to 060, and then multiple of 60
(i.e. In hours) are legible. The max interval time is 720 minutes (i.e. 12 hours). For
instance, #TLS0530E2130I120# means Starting Time 5:30, End Time 21:30, Interval
Time 120 minutes.
Command #SNAP# allows user to catch a snapshot from camera to send to the preset
recipient phone number or email..
G. Photo Quality:
User can choose the picture quality to be sent as either Normal or High.
Text Message Command Protocol
Example
Change Remote Control Mode
Disable
#RTOFF#
#RTOFF#
24 Hour
#RT24#
#RT24#
Once
#RT1HHMM#
#RT11130#
Change Time Lapse Setting
Disable
#TLD#
#TLD#
Change interval time
#TLNNNM#
#TL060M#
Reset time lapse setting
#TLSHHMMEHHMMINNN#
#TLS0530E2130I120#
Featured command
Snapshot
#SNAP#
#SNAP#
Change Sending Photo Resolution
To normal
#PQN#
#PQN#
To high
#PQH#
#PQH#