HCO MB600 User Manual
Page 21
Page | 20
Sending a picture takes 5s-60s depending on the network signal strength. SMTP
generally takes longer time than MMS.
USING CAMERA ONLY TO SETUP CELLULAR SETTINGS
1.
Set SEND MODE: Off, Instant, Customized, or Daily Report
2.
Set SEND VIA: MMS or smtp
3.
Set SEND TO: Phone, Email, or Both
4.
Set NETWORK SETUP:
NOTE: Push the OK button to select each letter/number. The disk icon is for saving
settings; the large left arrow button is for deleting, and the small right arrow is to
return to previous menu.
a.
Phone: enter phone number using arrows, press OK to save.
b.
Email: enter email address using arrows, press OK to save.
c.
Cellular Provider: select your provider from the menu. If your provider is
not present, you will need to use the „Download Tool‟ explained
previously.
5.
Set PHOTO QUALITY: Normal or High
6.
2G/3G MODE:
2Gmode uses GSM cellular frequencies. 3G mode uses HPSA/+ cellular
frequencies.
NOTE: If the network does not support GSM, user should switch to 3G mode only.
7.
Set REMOTE CONTROL: Disable, 24 Hour or Once.
NOTE: Explanations of the above settings are explained in greater detail previously in
manual (pg. 10
– 19).
Additional Notes:
Be sure your SIM card works on the GSM or HSPA service. This device supports
four bands: 850MHz, 900MHz, 1800MHz and 1900MHz.
If sending photos by MMS, you will want an MMS picture messaging plan. If
sending photos by SMTP account, you will want a Data plan on the SIM card.
There is a max limit on the number of pictures sent daily to your phone. Please
check the MAX number in "Instant" and "Custom" modes toset the desired number
of pictures.