HCO MB600 User Manual
Page 8
Page | 7
1. Select QUIET TIME
2.
Select desired „quiet time‟ and push OK to set
NOTE: The camera is only able to do one thing at a time; it has one internal
processor. When in cellular mode, the camera must finish transmitting the image
before it can capture a subsequent image. Average transmission speed will range 10
seconds to 3 minutes depending on the network strength at that time and location.
ILLUMINATION
This feature allows the user to use external lighting (XtendIR-B) or turn off IR lights if no
lights are required in the night. User selects Internal when they want the IR lights of
camera to work normally; select External if connecting XtendIR-B (sold separately) to the
camera OR to turn IR lights OFF at night, and Int + Ext if both the XtendIR-B and camera
IR lights are desired.
1. Select ILLUMINATION
2. Select Internal, External, or Internal + External and push OK to set
PIR SENSITIVITY
This allows the user to adjust motion sensitivity slightly. (Eg. High makes the camera
most sensitive.)
1.
Select PIR Sensitivity
2.
Select Low, Normal, High
DUTY TIME
This feature allows the user to program the camera to turn ON and OFF at a specified
time.
1.
Select DUTY TIME
2.
Select ENABLE to set up Duty Time or DISABLE to cancel Duty Time
SET START TIME
Set camera START time using arrows and push OK to set
SET STOP TIME
Set camera STOP time using arrows and push OK to set
3.
Push LEFT arrow button to return to menu
Note: For 24 hour activity: START: 00:00 and STOP 23:59
TIME LAPSE
This feature allows the camera to take pictures at a pre-set time interval (10 seconds to
12 hours) and record or send them over the network.