Soleus GPS Pulse (SG008) - Manual - Manual (Page 12)

Soleus GPS Pulse
6.3) Using TIMER mode:
RUN mode & TIMER mode has the same chronograph counter. When the chronograph is
started or stopped in RUN mode, the same thing happens in TIMER mode.
• The watch has 6 interval timers segment 1 to segment 6.
• The default values for all segments are 00:00:00.
• Please set the TIMERS first before using this mode.
• When you start the Chronograph in other modes like RUN mode, the set Timer
segments will also start counting down.
• When a segment reaches zero, there will be a 5 seconds beep sound and vibration
alarm. The next segment will auto start the countdown. The cycle will loop for 50 loops
and auto stop.
• If only 1 segment timer is set and the other segments are set to zero, only that segment
will countdown and loop up to 50 loops.
6.3.1. How to enter TIMER mode.
• Press S7 from Time mode to go to Timer mode.
The watch will prompt you to GPS GO (if Satellite signal already received) or INDOOR
(if no signal received).
6.3.2. How to START, STOP, and SAVE.
• Press S1 to start or re-start.
• Press S11to take LAP. If auto lap function is set, the watch will take lap automatically
based on auto lap setting and there is a beep sound during taking of auto lap.
• Press S1 to stop after completing your run.
• Press and hold S1 or press S11 to save your data.