Soleus GPS Pulse (SG008) - Manual - Manual (Page 7)

Soleus GPS Pulse
3.5) ALARM can also be set in ALARM quick SET mode.
• Press and hold S11 until alarm digit “1” blinks.
• Press S5 to set the hour, minute, T1/T2 and Alarm On/Off, Daily Alarm (MON to
SUN) and Chime.
Step 4) Acquire Satellite signals:
In order to get the correct time of day and begin using your watch, you have to acquire the
Satellite signals. It may take a few minutes to get the signals.
4.1) Go outside to an open area away from tall buildings and trees. Orient the GPS antenna
towards the sky for best reception. The antenna is located at the 12 o’clock position of
the watch.
4.2) Stand still and do not begin moving while locating the Satellites until the GPS signals are
already received.
4.3) How to Turn ON the GPS: Following are the possible ways to turn on the GPS.
4.3.1) Press S1 in TIME mode. The Watch will display the GPS / INDOOR selection
screen. Select GPS and press S5. The watch will start searching for GPS and go
to RUN mode once signal is received.
4.3.2) Press S7 to enter the RUN, CHRONO, TIMER or HRM. Select GPS and press
S5 to confirm.
4.3.3) Press and hold S7 for 2-3 seconds from any mode while GPS is initially OFF.
IMPORTANT NOTE:
v After GPS signal is received, the HRM will also automatically ON.
v When CHRONO is running, stop or save/reset, press and hold S7 will also turn OFF the
GPS.