Soleus GPS Pulse (SG008) - Manual - Manual (Page 2)

Soleus GPS Pulse
Step 2) Charging the Battery:
Charge the unit for at least 4-5 hours before first use. The length of time for a fully charged
battery will last depending on the actual usage. It is recommended to regularly re-charge your
battery every 1-2 months even if it is not used to maintain good battery condition.
2.1) Plug your USB PC link cable to your PC
2.2) Align the charging clip with the contacts on the back of the Watch.
2.3) Connect the charging clip securely to the watch.
Note: Please thoroughly dry the charging contacts and surrounding area to ensure
proper electrical contact and prevent corrosion.
Battery low condition:
You cannot turn ON the GPS when the battery is low. You need to recharge the battery in
order to use the GPS again.
When the battery is almost low and you still perform your exercise, your data may not be
saved. Please make sure the battery have enough battery power before doing your exercise
in order not to lose your data.
Water immersion:
This GPS Optic HRM watch, is designed to be water resistant up to 3 ATM. It can resist water
pressure up to 30 meters. After submersion to water, please make sure to wipe dry and air
dry the unit before using or charging.
Caution:
v Prolonged water submersion may cause electronic shorting in the unit which may
cause minor skin burn or irritation.
v Persons who are using Pacemakers should not use this device with the HRM belt.
Signal from the HRM belt may interfere with the pacemaker.
Step 3) Configure your Watch:
Before using your watch, please set your Watch.
3.1) While in TIME mode, press S7 to go to SET mode and set the following parameters:
AUTO LAP, TIME, UNIT, USER, HRM, NIGHT, CONTRAST, CHIME, ALARM, TIMER,
and VIEW.
• Press S1 or S11 to change the blinking parameter to set.
The watch will auto exit setting mode if there is no push button operation within 3 to 4
minutes.
How to set the AUTOLAP:
• Press S5 while AUTO LAP is blinking. The digit will start to blink.
• Press S1/S11 to change the setting. Auto lap preset settings are: off, 0.4, 1, 2, 3, 4,
and 5 KM.
• Press S5 to confirm and set ALERT ON or OFF.
• Press S1/S11 to change the setting. There is a beep sound and EL on for 10 sec every
auto lap taking when ALERT is set to ON.
• Press S5 to confirm setting and go back to Auto lap setting screen.
Auto Lap setting range: 0.4, 1, 2, 3, 4, 5, and OFF