Cutmaster a80 – Tweco A80 CutMaster User Manual
Page 30
CUTMASTER A80
INSTALLATION
Manual 0-4985
3T-2
3T.03 Setting Up Automation or Machine Torch
NOTE
An adapter is required to be installed in the power
supply if converting a hand torch system to operate
a machine or automation torch.
WARNING
Disconnect primary power at the source before
disassembling the torch or torch leads.
The Automation and Machine torch include a positioning tube
with rack and pinch block assembly.
1. Mount the torch assembly on the cutting table.
2. To obtain a clean vertical cut, use a square to align the
torch perpendicular to the surface of the workpiece.
Automated and Machine Torch Set - Up
3. The proper torch parts (shield cup, tip, start cartridge,
and electrode) must be installed for the type of opera-
tion. Refer to Section 4T.08, Torch Parts Selection for
details.