Tweco 1000 Merlin(Sept1999) User Manual
Merlin, Automated plasma cutting power supply (ce), Operating manual
Advertising
Table of contents
Document Outline
- SECTION 1: GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- 1.04 Note, Attention et Avertissement
- 1.05 Precautions De Securite Importantes
- 1.06 Documents De Reference
- 1.07 Declaration of Conformity
- 1.08 Statement of Warranty
- SECTION 2: INTRODUCTION
- 2.01 Scope of Manual
- 2.02 Power Supply General Description
- 2.03 Specifications & Design Features
- 2.04 Power Supply Options and Accessories
- 2.05 Theory Of Operation
- SECTION 3: INSTALLATION PROCEDURES
- 3.01 Introduction
- 3.02 Site Selection
- 3.03 Unpacking
- 3.04 Input Power Cable Connections
- 3.05 Gas Connections
- 3.06 Connecting Torch Leads To System Without Optional Remote Arc Starter
- 3.07 Work Cable And Ground Connections
- 3.08 Filling Power Supply Coolant
- 3.09 External Cable Connections
- 3.10 Lifting Options
- 3.11 Optional Remote Arc Starter
- SECTION 4: OPERATION
- 4.01 Introduction
- 4.02 Functional Overview
- 4.03 Front and Rear Panel Descriptions
- 4.04 Sequence of Operation
- 4.05 Preparations for Operating
- 4.06 Cut Quality
- 4.07 System Operation
- 4.08 Optional Power Supply Settings
- SECTION 5: MAINTENANCE & CUSTOMER/OPERATOR SERVICE
- 5.01 Introduction
- 5.02 Recommended Routine Maintenance Schedule
- 5.03 General Maintenance
- 5.03 Common Operating Faults
- 5.04 Common Operating Problems
- 5.05 Troubleshooting Guide
- 5.07 Test Procedures For Optional Remote Arc Starter
- 5.08 Power Supply Parts Replacement
- SECTION 6: PARTS LISTS
- 6.01 Introduction
- 6.02 Ordering Information
- 6.03 Complete System Replacements
- 6.04 Power Supply Replacement Only
- 6.05 Basic Replacement Parts
- 6.06 Options and Accessories
- APPENDIX I: INPUT WIRING REQUIREMENTS
- APPENDIX II: SEQUENCE OF OPERATION (BLOCK DIAGRAM)
- APPENDIX III: TYPICAL MECHANIZED SYSTEM GROUNDING DIAGRAM
- APPENDIX IV: TYPICAL MECHANIZED SYSTEM CABLE INTERCONNECTION DIAGRAM
- APPENDIX V: QUICK REFERENCE TO INTERCONNECTING CABLES AND HOSES
- APPENDIX VI: POWER SUPPLY CNC INTERFACE DIAGRAM
- APPENDIX VII: OPTIONAL REMOTE ARC STARTER INTERCONNECTING DIAGRAM
- APPENDIX VIII: 36 VAC CIRCUIT DIAGRAM
- APPENDIX IX: SYSTEM SCHEMATIC