Tweco XTTM-300 User Manual
Instruction manual xt, Liquid cooled plasma cutting torch, For distributor use with hypertherm
Advertising
Table of contents
Document Outline
- SECTION 1: GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- Section 2: Torch Specifications
- SECTION 3: INSTALLATION
- 3.01 Unpacking
- 3.02 Oxygen Plasma Pre-Charge Unit Installation
- 3.03 Oxygen Plasma Pre-Charge Unit Switch Setting
- 3.04 Connecting Torch
- 3.05 Consumables Selection
- 3.06 Oxygen Plasma Pre-Charge Unit Installation Checks
- 3.07 Oxygen Plasma Pre-Charge Unit Operational Check
- 3.07 Pre-Charge Unit Checks
- SECTION 4-A: OPERATION WITH MANUAL GAS CONSOLE
- SECTION 4B: OPERATION WITH 5-KNOB AUTOMATIC GAS CONSOLE
- 4B.01 Torch Parts Selection
- 4B.02 Pre-Setting Controls
- 4B.03 Recommended Cutting Speeds
- SECTION 4C: OPERATION WITH 6-KNOB AUTOMATIC GAS CONSOLE
- 4C.01 Torch Parts Selection
- 4C.02 Pre-Setting Controls
- 4C.03 Recommended Cutting Speeds
- Section 5: General Maintenance
- E. Coolant Leak Trouble-Shooting
- SECTION 6: PARTS LIST
- APPENDIX 1: ALTERNATE ARC VOLTAGE SETTINGS
- APPENDIX 2: WIRING DIAGRAM
- APPENDIX 3: PATENT INFORMATION