Tweco 200 XT Ultra-Cut Plasma Cutting System - Manual (Page 28)

ULTRA-CUT 200 XT
3-4 INSTALLATION Manual 0-5273
3.05 Lift the Power Supply
WARNINGS
Do not touch live electrical parts.
Disconnect input power conductors from de-energized supply line before moving unit.
FALLING EQUIPMENT can cause serious personal injury and equipment damage.
Use a forklift, crane, or hoist to lift the unit off the shipping pallet as shown. Keep the power supply steady and
vertical. Do not lift it any further than necessary to clear the shipping pallet. Ensure all panels and screws are secure
prior to lifting.
Art # A-11531_AC
Set the power supply on a solid, level surface. The installer may fasten the power supply to the floor or a sup-
porting fixture with hardware passing through the horizontal parts of the power supply feet.