Tweco 200 XT Ultra-Cut Plasma Cutting System - Manual (Page 53)

ULTRA-CUT 200 XT
Manual 0-5273 INSTALLATION 3-29
3. The Arc Starter must be grounded; the grounding terminal is marked . Refer to the previous section for
grounding details.
Ground Cable
Art # A-04758
1 Nut and 1 Washer
Remain in Place
Torch Leads
4. Use a clamp to secure the Torch Lead Shield braid brass ring to the port on the Remote Arc Starter as shown.
Art # A-04759
Coolant and Pilot Leads
to Torch Valve Assembly
Torch Leads Shield
Shield Clamp