Section 11: voltage reduction device (vrd), Arcmaster 300 acdc – Tweco 300 DC Arcmaster User Manual
Page 58
ARCMASTER 300 ACDC
10-8
February 22, 2006
Strike an arc to complete the
weld cycle.
OR
Switch machine off then on
to reset solenoid valve
sequence.
B Gas valve is faulty.
B Have an Accredited Thermal
Arc Service Agent repair or
replace the gas valve
C Gas valve jammed open.
C Have an Accredited Thermal
Arc Service Agent repair or
replace the gas valve
D
POST-FLOW
control is set
to 60 sec.
D Reduce
POST-FLOW
time.
6 The TIG electrode has
been contaminated
due to the gas flow
shutting off before the
programmed
POST-
FLOW
time has
elapsed.
The Weld Process Mode
(STICK, HF TIG or LIFT TIG)
was changed before
POST-
FLOW
gas time had
finished.
Do not change Weld
Process Mode before the
POST-FLOW
gas time had
finished.
A
Description
Possible Cause
Remedy
5 Gas flow won’t shut
off.
A Weld Mode (
STD
,
SLOPE
,
REPEAT
or
SPOT
) was
changed before
POST-
FLOW
gas time had
finished.
Table 10-3 (continued): Power Source Problems