Tweco HMC-410 - Manual (Page 73)

HMC-410
July 27, 2005 6-1
SECTION 6:
ACCESSORIES AND OPTION
DESCRIPTIONS
6.01 Remote Pendant Description
The remote pendant is an option for remote control
operation of the control panel. Features under remote
control include Cycle Start, Cycle Stop, Wire Feed
(Inch), and Gas Purge. If the remote pendant is not to
be used, this section can be skipped. The Remote
Pendant is shown in Figure 6-1.
CYCLE START BUTTON - This button is used for remote
pendant initiation of the weld cycle. When pressed, the
control will initiate the selected weld schedule. Pressing
this button while in a weld has no effect.
CYCLE STOP BUTTON - This button is used for termination
of the remote pendant initiated weld cycle. When pressed,
the control will proceed to the crater fill segment of the
weld cycle. Also, recycle will be disabled so that the weld
will stop after the postflow segment. Pressing this button
during a gun switch, front panel, or fixture initiated weld,
or during standby, will have no effect.
Gas PURGE BUTTON - This button will turn on the gas
valve when pressed. This button has no effect during a
weld.
INCH BUTTON - This button will feed wire (at the rate
programmed in the Run In WFS setting) when pressed.
This button has no effect during a weld.
6.02 Feedhead
170896A-002 60 - 888 IPM
6.03 Feed Roll Kits
375980-XXX (one kit is supplied standard, but part
number must be specified at time of order).
Art # A-04369
Figure 6-1: Remote Pendant