Tweco HMC-410 - Manual (Page 83)

HMC-410
July 27, 2005 8-1
SECTION 8:
PARTS LIST
8.01 Equipment Identification
All identification numbers as described in the Introduction
chapter must be furnished when ordering parts or making
inquiries. This information is usually found on the
nameplate attached to the equipment. Be sure to include
any dash numbers following the Specification or Assembly
numbers.
8.02 How To Use This Parts List
The Parts List is a combination of an illustration (Figure
Number) and a corresponding list of parts which contains
a breakdown of the equipment into assemblies,
subassemblies, and detail parts. All parts of the equipment
are listed except for commercially available hardware, bulk
items such as wire, cable, sleeving, tubing, etc., and
permanently attached items which are soldered, riveted,
or welded to another part. The part descriptions may be
indented to show part relationships.
To determine the part number, description, quantity, or
application of an item, simply locate the item in question
from the illustration and refer to that item number in the
corresponding Parts List.
An “Application Code” is used to distinguish parts that
are applicable only to certain Specifications and/or
Assemblies. This code is found in the right most column
of the Parts List. If an item in the Parts List applies to all
Specifications or Assemblies, the word “ALL” will be in
the Application Code column. Refer to the following list to
determine the appropriate Application Codes for the
Specifications or Assemblies covered by this manual. If
only the assembly or specification number is listed, the
use of an Application Code does not apply to this manual.
SPEC NUMBER APPLICATION CODE
100050-1 A
100050-2 B