Figure 35. rfid configuration screen – Unitec Sierra Management System User Manual
Page 43
Sierra Programming Reference Manual
33
Figure 34. Sentinel Dual Bill Dispenser Configuration Screen
1.
Select the bill dispenser manufacturer from the drop-down menu: Telaris, LG, or MFS.
2.
Select the bill denomination for each slot: $1, $5 or $10.
3.
The Low Limit setting is used to determine when a notification is to be sent to warn that the coin
dispenser is low on change. Select whether or not you wish to receive a notification when the bill
dispenser reaches the Low Limit by clicking Enable. The recommended setting is to send a warning
when it’s at 10% capacity and the default setting is 200 bills.
4.
Click Save.
Figure 35. RFID Configuration Screen
The ReachFree ID screen allows you to define settings for an RFID reader, if the reader is installed onsite.
You may set the reader to be on continuously or to be activated when a vehicle is detected by the Entry
unit’s proximity sensor.
1.
Select either Always On or Controlled Via Proximity Sensor. The default and recommended setting
is Always On.
2.
Click Save.