Figure 41. wash select ii wash settings screen – Unitec Sierra Management System User Manual
Page 48
Sierra Programming Reference Manual
38
Once the wash packages to be offered are selected, configure them by selecting the associated Product
Settings button in the table.
Figure 41. Wash Select II Wash Settings Screen
1.
The alternate relay pattern is used to notify the wash controller of a change that’s required in the
wash service. A typical use would be to set a ‘hybrid’ wash for either a ‘touch free’ or ‘soft touch’
wash delivery. When an alternate relay pattern is enabled, a customer option message must also
be set in the User Interface set-up.
2.
Select any Added Services you wish to offer with this wash package from the drop-down menus in
the order you wish them to be displayed.
3.
Enter any additional information about the wash package, if you wish. This field is limited to 16
characters.
4.
Edit each wash package as stated above and click Save. When you are finished, click Next to proceed
to the Wash Interface page.
NOTE: The wash interface settings must be set up at the Wash Select II unit!