Unitec American Parking Equipment - Manual (Page 39)

Document Number: GC1001 35
Document Title: Unitec APE Gate and Gate Controller for Multi-Lane Applications Installation Guide
5. Verify Gate at Lane 3 opens. If not, view the LCD screen on the PLC. If it
shows “IDLE/SCANNING” still, then it is not getting the signal into
X2/terminal 23 from the WSII. Check your wiring from the Gate Controller
to J19 of the Wash Select II. If it shows “Open Gate 3” then check the
wiring from the Gate Controller Y6/Terminal 53 to the Gate terminal strip.
6. If everything is operating correctly, X6 LED on the PLC should be lit and
the LCD screen on the Gate controller should show “Wait for Gate 3”. If
not, verify wiring from X6/Terminal 33 to the Gate terminal strip.
7. With the Gate for lane 3 open, drive a car through Lane 3. Validate that
the Gate lowers after the rear of the vehicle comfortably passes off the
Gate Loop.
8. After the gate for Lane 3 closes, the LCD screen on the Gate controller
should either show “Car in Merge area” (if you have a Merge loop
installed). Or “Idle/Scanning”
9. If you have connected the wash arming signals to your Tunnel controller,
you should verify a wash has been queued. If not, verify connections on
J17 of the WSII to the Tunnel controller.
Testing for Lane 3 is complete.
5.4 Testing System Interface for Lane 4
1. Remove any vehicles below all gate loops and merge loop.
2. Verify that all Gates have power and the gates are down. Gates should
be switched to Automatic mode.
3. Verify on the door of the Wash Select II that the “Wash In Use” LED is lit.
If not, check the wiring from Y4/Terminal 44 of the Gate controller and
terminal 11 to J18 of the WSII
4. Arm a wash at the Wash Select II in Lane 4.
5. Verify Gate at Lane 4 opens. If not, view the LCD screen on the PLC. If it
shows “IDLE/SCANNING” still, then it is not getting the signal into
X3/terminal 24 from the WSII. Check your wiring from the Gate Controller
to J19 of the Wash Select II. If it shows “Open Gate 4” then check the
wiring from the Gate Controller Y7/Terminal 54 to the Gate terminal strip.
6. If everything is operating correctly, X7 LED on the PLC should be lit and
the LCD screen on the Gate controller should show “Wait for Gate 4”. If
not, verify wiring from X7/Terminal 34 to the Gate terminal strip.
7. With the Gate for lane 4 open, drive a car through Lane 4. Validate that
the Gate lowers after the rear of the vehicle comfortably passes off the
Gate Loop.
8. After the gate for Lane 4 closes, the LCD screen on the Gate controller
should either show “Car in Merge area” (if you have a Merge loop
installed). Or “Idle/Scanning”
9. If you have connected the wash arming signals to your Tunnel controller,
you should verify a wash has been queued. If not, verify connections on
J17 of the WSII to the Tunnel controller.
Testing for Lane 4 is complete.