Viking Pump NORD TSM For NORDBLOC.1 Reducers - Manual (Page 3)

DRIVESYSTEMS
SAFETY NOTES
RETAIN FOR FUTURE USE U10020 - 1 of 2
1. Safety & information symbols
All work including transportation, storage, installation, elec-
trical connection, commissioning, servicing, maintenance and
repair must be performed only by qualified specialists or
personnel. It is recommended that repairs to NORD Products
are carried out by the NORD Service Department. Instructions
related to operational safety will be emphasized as shown.
Symbol Meaning
General Warning or Hazard - Severe risk or danger
of personal injury or death by working around dan-
gerously high electrical voltage or moving machinery.
Proper safety precautions must be taken.
STOP
Possible Harmful Situation - Care must be taken to
avoid the possibility of damaging the drive unit, driven
machine, or the environment.
Important Note - Useful note or tip to help assure
trouble-free operation.
Material Disposal Note - Important note concerning
suggested material disposal.
2. Safety warnings
‡ All work involved in the transport, connection,
commissioning and maintenance of any NORD
product must be carried out by qualified and respon-
sible technicians. All applicable national, regional,
and local work regulations and safety requirements
must also be complied with. NORD assumes no
liability for personal injury, accidental death, or
equipment damage and malfunctions resulting from
failure to comply with installation or operating
instructions, safety notes, or any work regulations
and laws!
t
(FBS
VOJU
JOTUBMMBUJPO
BOE
NBJOUFOBODF
XPSL
NBZ

only be performed when no power is available to
the prime mover or motor. Electric motors,
electrical brakes, and variable frequency drives,
contain potentially dangerous high-voltage. Prior to
installation or maintenance, shut down the power at
the circuit breaker or power switch. While working
on the drive, make sure the power from the prime
mover is isolated or secured on “lock-out” to prevent
accidental start-up and to safeguard against injury!
t
4VSGBDFT
PG
NPUPST
BOE
HFBS
VOJUT
NBZ
CFDPNF
IPU

during operation or shortly after start-up. In some
instances additional protection against accidental
contact may be necessary. Use caution to avoid burns
or serious injury!
GENERAL WARNINGS
3. Observe published performance range
& nameplate data
Observe the data on all reducer nameplates and verify
published ratings for the NORD item/s in question.
Do not operate any NORD equipment outside the
published performance range. Failure to comply may
result in damage to the drive unit, driven machine, or
the environment.
HARMFUL SITUATION
STOP STOP
U.S. Nameplate
NORD GEAR CORPORATION-USA / WWW.NORD.COM
SK
S/N
RATIO
TORQUE
SPEED
LUBRICATION
SEE MANUAL
FOR GEAR
MTG POS
RPM
LB-IN
SF
120094630
DRIVESYSTEMS
European Nameplate
DRIVESYSTEMS
Type SK
No.
i=
n2= min
Siehe Wartungsanleitung
See maintenance instructions
Voir instructions d entretien
-1
0
8
5 0
1
57
-0
Getriebebau NORD
GrbH&Co KG
D - 22934 Bargteheide
4. Transportation and handling
Make sure that all eyebolts and lifting lugs are tight and
lift only at designed points. Protect the mounting surface
from possible damage during transportation.
WARNING
Do not attach other machinery or loads to the NORD
assembly, since the supplied lifting bolts are not
designed for this purpose.
If the gearmotor or assembly is equipped with two sus-
pension eye bolts, then both locations should be used for
transportation and placement of the unit; in this case the
tension force of the slings must not exceed a 45° angle.
In some instances it may be appropriate to use additional
lifting straps or slings in order to assure safe transportation
of the assembly. Always use sufficiently rated handling
equipment and ensure that adequate safety measures
are taken to protect personnel from injury during trans-
portation. Once the NORD assembly is properly installed,
remove the transportation fixtures.
n Model/Type
o Serial Number
p (FBS
3BUJP
q Service Factor
r Torque Rating
s Output Speed RPM
t Mounting Position
n Model/Type
o Serial Number
p (FBS
3BUJP
q Speed
www.nord.com/docs 06.09.09
NORD Gear Corporation
Toll Free in the United States: 888.314.6673
NORD Gear Limited
Toll Free in Canada: 800.668.4378