Viking Pump TSM710: KE-LQE 4076/4176 - Manual (Page 5)

iTeM NaMe Of ParT iTeM NaMe Of ParT
1 Locknut 21 Relief Valve
2 Lockwasher 22 O-Ring For Relief Valve / Cover Plates
3 End Cap 23 Casing Bushing
4 Lip Seal (2-Req’d) 24 Capscrews For Relief Valve / Cover Plate (8-Req’d)
5 Bearing Spacer Collar (Outer) 25 Cover Plates (2-Req’d)
6 Ball Bearing - KE & KKE / Roller Bearing - LQE (2-Req’d) 26 Rotor and Shaft Assembly
7 Bearing Spacer Collar (Inner) 27 Idler and Bushing Assembly
8 Half Round Ring (2-Req’d) 28 Idler Bushing
9 Nylon Slug (2-Req’d) 29 O-Ring For Head
10 Setscrew, M8 - 1.25 x 8 mm (2-Req’d) 30 Lube Pin
11 Setscrew, M8 - 1.5 x 14 mm (2-Req’d) 31 Head and Lube Idler Pin Assembly
12 Bearing Housing 32 Pipe Plug, Hex Head, 1/4” BSP
13 Capscrews For Seal Plate (2-Req’d) 33 O-Ring For Jacketed Head Plate
14 Mechanical Seal Plate 34 Jacketed Head Plate
15 O-ring For Seal Plate 35 Head Capscrews
16 Mechanical Seal 36 Foot (4176 Models Only)
17 Casing and Bushing Assembly 37 Dowel Pins (4176 Models Only)
18 Grease Fitting, 1/8” NPT 38 Capscrews For Foot (4176 Models Only)
19 Flush Line Assembly 39 Lockwashers For Foot (4176 Models Only)
20 Pipe Plug, Hex Head, 1/4” BSP (2-Req’d) Not lllus. Pipe Flange Gasket (2-Req’d)
SECTION TSM 710 ISSUE D PAGE 5 OF 8
figure 6
exPLODeD vieW Of viKiNg SerieS 4076 / 4176 PuMPS
TabLe 2