Viking Pump TSM710: KE-LQE 4076/4176 - Manual (Page 8)

SeCTiON TSM 710
Page
8 Of 8
iSSue D
VIKING PUMP, INC. • A Unit of IDEX Corporation •
Cedar Falls, IA 50613 USA
© 3/2013 Viking Pump Inc.
All rights reserved
TECHNICAL SERVICE MANUAL
WARRANTY
Viking warrants all products manufactured by it to be
free from defects in workmanship or material for a
period of one (1) year from date of startup, provided
that in no event shall this warranty extend more than
eighteen (18) months from the date of shipment from
Viking. The warranty period for Universal Seal series
pumps ONLY (Universal Seal models listed below) is
three (3) years from date of startup, provided that in
no event shall this warranty extend more than forty-two
(42) months from the date of shipment from Viking.
UNDER NO CIRCUMSTANCES SHALL VIKING BE
LIABLE UNDER THIS WARRANTY OR OTHERWISE
FOR SPECIAL, INCIDENTAL, INDIRECT,
CONSEQUENTIAL OR PUNITIVE DAMAGES OF ANY
KIND, INCLUDING, BUT NOT LIMITED TO, LOST
OR UNREALIZED SALES, REVENUES, PROFITS,
INCOME, COST SAVINGS OR BUSINESS, LOST OR
UNREALIZED CONTRACTS, LOSS OF GOODWILL,
DAMAGE TO REPUTATION, LOSS OF PROPERTY,
LOSS OF INFORMATION OR DATA, LOSS OF
PRODUCTION, DOWNTIME, OR INCREASED
COSTS, IN CONNECTION WITH ANY PRODUCT,
EVEN IF VIKING HAS BEEN ADVISED OR PLACED
ON NOTICE OF THE POSSIBILITY OF SUCH
DAMAGES AND NOTWITHSTANDING THE FAILURE
OF ANY ESSENTIAL PURPOSE OF ANY PRODUCT.
THIS WARRANTY IS AND SHALL BE VIKING’S SOLE
AND EXCLUSIVE WARRANTY AND SHALL BE IN
LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING, BUT NOT LIMITED
TO, ALL WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE AND
NON-INFRINGEMENT ALL OF WHICH OTHER
WARRANTIES ARE EXPRESSLY EXCLUDED.
See complete warranty at www.vikingpump.com.
iMPOrTaNT
When ordering parts for a pressure relief valve, always
give the model number and serial number of the pump as
it appears on the nameplate. Also specify the name of the
part(s) wanted. When ordering springs, be sure to give the
pressure settings desired.
1 2 3 4 5 7 8 6
9 10
A
vaLve - LiST Of ParTS
1. Valve Cap 6. Valve Body
2. Adjusting Screw 7. Valve Spring
3. Lock Nut 8. Poppet
4. Spring Guide 9. Cap Gasket
5. Bonnet 10 Bonnet Gasket
figure 9
reLief vaLve PreSSure aDJuSTMeNT:
If a new spring is installed or if the pressure setting of the
pressure relief valve is changed from what the factory has
set, the following instructions must be carefully followed.
1. Carefully remove the valve cap that covers the adjusting
screw. NOTe: this cap will most likely contain liquid.
2. Loosen the locknut that locks the adjusting screw so
the pressure setting will not change while the pump is
in operation.
3. Install a pressure gauge in the discharge line for actual
adjustment operation.
4. Turn the adjusting screw in to increase the pressure and
out to decrease the pressure.
5. With the discharge line closed at a point beyond the
pressure gauge, the gauge will show the maximum
pressure that the valve will allow while the pump is in
operation
iNDuSTriaL heavy DuTy MOTOr SPeeD PuMPS
SerieS 4076 aND 4176
SiZeS Ke, KKe aND LQe