Summary steps, Detailed steps – Cisco OL-7822-06 User Manual
Page 15
2-5
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 2 Rack-Mount the SCE 1000
Mount the System to the Rack
SUMMARY STEPS
1.
Make sure that the rack brakes are locked or that the rack is otherwise stabilized.
2.
Position the SCE 1000 so that the front end is closest to you, and lift it carefully to place it into the
rack. To prevent injury, avoid sudden twists or moves.
3.
Slide the SCE 1000 into the rack, pushing it back until the brackets (installed at the front of the SCE
1000) meet the mounting strips or posts on both sides of the rack.
4.
While keeping the brackets flush against the posts or mounting strips, align the holes in the brackets
with the holes on the rack or mounting strip.
5.
For each bracket, insert and tighten two appropriate screws to the rack.
DETAILED STEPS
Step 1
Make sure that the rack brakes are locked or that the rack is otherwise stabilized.
Figure 2-7
Sliding the SCE Platform into the Rack
Step 2
Position the SCE 1000 so that the front end is closest to you, and lift it carefully to place it into the rack.
To prevent injury, avoid sudden twists or moves.
Step 3
Slide the SCE 1000 into the rack, pushing it back until the brackets (installed at the front of the SCE
1000) meet the mounting strips or posts on both sides of the rack.
LINK RX
Cisco SCE 20
00 Series
4xGBE
TX
RX
MM
TX
LINK RX TX
RX
MM
TX
LINK RX TX
RX
MM
TX
LINK RX TX
RX
MM
TX
GBE-1
SUB
LINE
NET
PWR B STATU
S
PWR A
BYPASS
10/100/
1000
LINK/
ACTIVE
10/100/
1000
LINK/
ACTIVE
GBE-2
SUB LINE/CAS
CADE NET
AUX
CONSOLE
MNG 2
MNG 1
LINK RX TX
RX
MM
TX
LINK RX TX
RX
MM
TX
PWR B STATU
S
PWR A
BYPASS
10/100/
1000
LINK/
ACTIVE
10/100/
1000
LINK/
ACTIVE
AUX
CONSOLE
MNG 2
MNG 1
Cisco SC
E 1000
Series
2xGBE
GBE-1
SUB
LINE
NET
1
2
3
210419