Cisco OL-7822-06 - Manual (Page 4)

Contents
iv
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
EXAMPLE: 4-8
Step 4: Configuring Time Settings 4-8
EXAMPLE: 4-10
Step 5: Configuring the DNS Settings 4-10
EXAMPLE: 4-11
Step 6: Configuring the RDR Formatter Destination 4-12
EXAMPLE: 4-12
Step 7: Configuring Access Control Lists (ACLs) 4-12
Information About Access Control Lists 4-12
Examples 4-15
Step 8: Configuring SNMP 4-16
EXAMPLE: 4-19
Step 9: Configuring the Topology-Dependent Parameters 4-20
About the Topology-Dependent Parameters 4-20
Examples 4-21
Step 10: Completing and Saving the Configuration 4-22
Examples 4-24
Connect the Management Interface 4-25
EXAMPLE: 4-25
C H A P T E R
5 Cable the Line Ports 5-1
Information About Cabling 5-1
Single Link: Inline Topology 5-1
Single Link: Receive-only Topology 5-2
Cabling the Line Interfaces 5-3
Configure GigabitEthernet Auto-Negotiation 5-3
Connect the GBE Line Interface Ports 5-4
C H A P T E R
6 Completing the Installation 6-1
Examining the LEDs 6-1
Final Tests 6-1
Verifying Operational Status 6-1
Example: 6-2
Viewing the User Log Counters 6-2
EXAMPLE: 6-2
Viewing Configuration 6-2
Saving the Configuration Settings 6-3
Examples 6-4
EXAMPLE 1: 6-4