Cisco OL-7822-06 User Manual
Page 25
4-5
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
Perform the Initial System Configuration
Following are some general instructions regarding the setup dialog:
•
All default values appear in square brackets [default] .
If no value appears in the brackets [], or more than one option appears [ yes/no ], then this parameter
does not have a default value.
Access Control List number
How many ACLs will be necessary? What IP
addresses will be permitted/denied access for each
management interface? You may want ACLs for
the following:
•
Any IP access
•
Telnet access
•
SNMP GET access
•
SNMP SET access
list entries (maximum 20 per list)
IP address, and whether permitted or denied
access.
IP access ACL
ID number of the ACL controlling IP access.
telnet ACL
ID number of the ACL controlling telnet access.
SNMP agent status
Enable or disable SNMP management.
GET community names
Community strings to allow GET access and
associated ACLs (maximum 20).
SET community names
Community strings to allow SET access and
associated ACLs (maximum 20).
trap managers (maximum 20)
Trap manager IP address, community string, and
SNMP version.
Authentication Failure trap status
Sets the status of the Authentication Failure traps.
enterprise traps status
Sets the status of the enterprise traps.
system administrator
Name of the system administrator.
Topology Configuration
connection mode
Is the SCE 1000 installed using inline topology or
receive-only topology using an optical splitter?
link bypass mode on operational status
When the SCE 1000 is operational, should it
bypass traffic or not?
link bypass mode on non-operational status
When the SCE 1000 is not operational, should it
bypass traffic or cut it off?
priority
(cascade topology only)
If this is a cascaded topology, is this SCE 1000 the
primary or secondary SCE 1000?
operational status of the SCE after abnormal boot After a reboot due to a failure, should the SCE
1000 remain in a Failure status or move to
operational status provided no other problem was
detected?
Table 4-1
Setup Command Parameters (continued)
Parameter
Definition