Cisco OL-7822-06 - Manual (Page 49)

5-3
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 5 Cable the Line Ports
Cabling the Line Interfaces
Figure 5-2 External Splitting Topology
Cabling the Line Interfaces
• Configure GigabitEthernet Auto-Negotiation, page 5-3
• Connect the GBE Line Interface Ports, page 5-4
Configure GigabitEthernet Auto-Negotiation
By default, the SCE 1000 GBE line interface ports are configured with auto-negotiation disabled.
Note If you change any parameters, you must save the new configuration settings. Type copy
running-config startup-config , and press Enter.
Step 1 At the SCE 1000# prompt, type configure and press press Enter.
Enters Global Configuration Mode.
Step 2 At the SCE 1000(config)# prompt, type interface GigabitEthernet 0/ portnumber , and press press
Enter.
Enters the GigabitEthernet Interface configuration mode for the specified GBE port.
portnumber is the number of the selected port (1 or 2).
Step 3 At the SCE 1000(config if)# prompt, type auto-negotiate and press press Enter.
Enables auto-negotiation for the GBE interface.
Step 4 At the SCE 1000(config if)# prompt, type exit and press press Enter.
Cisco SCE 1000 Series
2xGBE
LINK RX TX
RX MM TX
LINK RX TX
RX MM TX
GBE-1
SUB LINE NET
PWR B STATUS PWR A BYPASS
Router
Optical
splitter
Router
Subscriber
210417
Network