Example, Step 4: configuring time settings – Cisco OL-7822-06 User Manual
Page 28
4-8
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
Perform the Initial System Configuration
•
May contain only printable characters
Note
Passwords are case sensitive.
Note
The default password for all levels is “ Cisco ”.
Step 1
Configure the User password
The default User password is displayed.
•
To accept the displayed value, press press Enter.
•
To change the value, type the desired string and press press Enter.
Step 2
Configure the Admin password.
The default Admin password is displayed.
•
To accept the displayed value, press press Enter.
•
To change the value, type the desired string and press press Enter.
Step 3
Configure the Root password.
The default Root password is displayed.
•
To accept the displayed value, press press Enter.
•
To change the value, type the desired string and press press Enter.
Step 4
Configure password encryption. By default, password encryption is not enabled.
•
To disable password encryption, press Enter.
•
To enable password encryption, type y and press Enter.
EXAMPLE:
Following is an example of changing all passwords. Password encryption is not enabled (default).
Enter a User password [Cisco]: userin
Enter an Admin password [Cisco]: mng123
Enter a Root password [Cisco]: cistech
Enable passwords encryption? [no]:
Step 4: Configuring Time Settings
The time settings menu configures all time and date related parameters in the system. The time settings
menu includes the following:
•
Time zone
•
Local time
•
Date
•
SNTP menu