Cisco OL-7822-06 - Manual (Page 12)

2-2
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 2 Rack-Mount the SCE 1000
Attach the Brackets to the SCE 1000
Figure 2-2 Mounting Bracket for 4-post Racks
The SCE 1000 mounts to the two front rack posts with brackets that attach to the front of the SCE 1000
The inside width between the two posts or mounting strips (left and right) must be at least 17.3 inches
(44 cm).
Note Remember to leave a two-inch (5 cm) clearance on both sides of the SCE 1000 and at the rear for
adequate airflow for the inlet and exhaust vents.
Attach the Brackets to the SCE 1000
Before installing the SCE 1000 in the rack, you must first install an appropriate rack-mount bracket on
each side of the front of the SCE 1000, as illustrated in the following figures.
Figure 2-3 Attaching the Mounting Brackets (4-post)
210430
LINK RX TX
RX MM TX
LINK RX TX
RX MM TX
PWR B STATU S PWR A
BYPASS
10/100/ 1000 LINK/ ACTIVE 10/100/ 1000 LINK/ ACTIVE
AUX CONSOLE MNG 2 MNG 1 Cisco SCE
1000 Series 2xGBE
GBE-1 SUB LINE NET
1 2
210418