Great Plains 3S-5000HDF Operator Manual - Manual (Page 23)

Great Plains Manufacturing, Inc. Table of Contents Index Preparation and Setup 19
2012-08-14 Table of Contents Index 195-325M
Refer to Figure 8
3.
To align the clutch jaws from front to rear, loosen the
two
1 ⁄
2
inch carriage bolts and slide breakaway
clutch in the desired direction.
4. To adjust clutch jaws for full jaw contact, loosen the
two
1 ⁄
2
inch carriage bolts and slide breakaway
clutch until jaws on the fixed half of clutch make
full contact with jaws on spring loaded half of clutch
without compressing clutch spring.
Refer to Figure 9
Note: The two
7 ⁄
8
inch (19 mm) hex shafts should have
1 ⁄
8
inches (3.2 mm) between them when the clutch
jaws have full contact.
3
4
3
4
Figure 8
Transfer Drive Shaft Vertical Adjustment
34381
3
2
4
Figure 9
Hex Shafts
18955
1/8in (3.2mm)
5