Parking, Parking with drill unfolded, Parking with drill folded – Great Plains 3S-5000HDF Operator Manual User Manual

Page 44

Advertising
background image

40

3S-5000/F/HD/HDF

Table of Contents

Index

Great Plains Manufacturing, Inc.

195-325M

Table of Contents

Index

2012-08-14

Parking

For information on long-term storage, see “Storage” on
page 41.

Parking with Drill Unfolded

This drill has a negative tongue weight when unfolded and
openers are raised. Lower parking stand, lower openers and
remove hydraulic down pressure before unhitching the drill in
the unfolded position. Unhitching in the unfolded position with
the openers raised could result in sudden elevation of the
tongue, causing injury or death.

1.

Remove jack from its storage location on top of
tongue and pin it on post on left side of tongue as
shown in Figure 10 on page 21. Extend jack until
weight of tongue is on jack.

Refer to Figure 35 and Figure 36
2.

Lower parking stands located on outer ends of drill
by unpinning keeper pin

and rotating stands

down. Place a block under foot of stand if it does not
contact the ground.

3.

Lower openers and reduce hydraulic down pressure
to zero.

4.

Unplug drill hydraulic hoses and electrical lines from
tractor.

Use caution when removing the hitch pin. Slight tongue
elevation may occur.

5.

Remove hitch pin first, then safety chain from tractor
drawbar.

Note: After unhitching the unfolded drill, the tongue may

rise above tractor-drawbar height. Lower tongue by
connecting the opener-lift circuit and pressurizing
openers.

Parking with Drill Folded

Always transport markers folded flat. Make sure second
marker section rests securely on transport carrier.
1.

Raise, lock and fold drill into transport position.

2.

Park drill on a level, solid area.

3.

Remove jack from its storage location on top of
tongue and pin it on post on left side of tongue as
shown in Figure 10 on page 21. Extend jack until
weight of tongue is on jack. If ground is soft, place a
board or plate under jack to widen ground-contact
area.

4.

Unplug hydraulic hoses and electrical lines from
tractor.

5.

Remove hitch pin first, then safety chain from tractor
drawbar.

Figure 35

Parking Stand in Storage Position

18837

1

1

Figure 36

Parking Stand in Parking Position

15565

1

Advertising
This manual is related to the following products: