Great Plains YP1625 Material Rate - Manual (Page 34)

401-226B 8/8/2006
34
Veris Drive Calibrating Instructions
Calibration
Refer to Figure 1
1. Turn on Controller Console by pressing On/VR
key. Green light above On/VR key will illuminate
when power is on. Adjust desired planting rate
by using the Up/Down arrow keys to change the
Set rate.
2. Set the desired Rate by using the Up/Down ar-
row keys.
Refer to Figure 2
3. Press Function key until Calibration Number
window appears. Select drive calibration num-
ber based on row spacing and metering wheel
from the Veris Drive Calibration Numbers Chart.
Use Up/Down arrow keys to set Calibration
Number.
Refer to Figure 3
4. Press Function key until the Calibration win-
dows appears as shown.
5. Press Up arrow key to enter calibration mode.
22715
22778
22717
Figure 1
Figure 2
Figure 3