Great Plains PM400 Monitor Operator - Manual (Page 36)

OPERATOR’S MANUAL
PM300, PM332, PM400 Planter Monitors
11001-1372-200606
30 / ADVANCED SETUP
UNITS OF MEASUREMENT, BACKLIGHTING AND
ALARM VOLUME CONTROL
The display screen can be customized by changing the units of
measurement to English or Metric, control backlight intensity and increase
or decrease alarm volume.
Figure 18
Display & Service Screen
To change Units, Backlight, and Alarm Volume:
1. Press Display & Service key.
2. Press the Down Arrow key to highlight Units, Backlight or Alarm
Volume icon.
3. Press Enter to highlight the setting to change and the Up and Down
Arrow key to cycle through selection.
4. Press Enter to confirm the desired selection.
SERVICE SCREEN
The service screen provides information about the monitor’s software and
hardware versions, total hours of operation, total acres covered, battery
voltage, hopper level 1 and 2 sensor status, and lift switch status. (refer to
Figure 19).
To display the service screen:
1. Press the Display & Service key.
2. Highlight the Service icon and press Enter.
DISPLAY
&
SERVICE
123.4
43.8
1 2 3 4
123.4
43.8
1 2 3
M
E
E Units, Backlight, Alarm Volume
Service
Security
Upper
Setup
Lower
Setup
M
E
E
ENTER
Units
Backlighting
Volume
Up or Down Arrow keys
Enter key
Service icon