Great Plains TC5319 (S/N A1420X+) Operator Manual - Manual (Page 20)

16 TC5109-5323 Great Plains Manufacturing, Inc.
566-224M 03/06/2014
Wing Adjustment (5313-5315)
Refer to Figure 10
17. Once the machine is level fore to aft, the wings may be
leveled (Models 5313-5315). Start by unfolding the
wings to a rigid position.
18. Completely extend the wing fold cylinders and check
the wings for levelness. If machine is not level, fold
wings back up and instal shims as needed to level.
Note: Extra shims are stored in manual pak. The extra
shims may be needed in the future if the hinge holes or
bolts begin to wear. There are two different thickness
of shims, you may use multiple shims to level wings.
19. Remove the two 3/8 x 1 1/2 bolts and either add more
shims to raise wings or take shims out to lower wings.
20. Re-instal bolts and tighten to specs, see “Torque Val-
ues Chart” on page 30.
Wing Adjustment (5317-5323)
Refer to Figure 11
21. The wings are to be leveled with the turnbuckle on
the wing cylinder mount .
22. Loosen jam nut and either shorten turnbuckle to raise
the wings or lengthen the turnbuckle to lower the wings.
23. Re-tighten the jam nut to specs, see “Torque Values
Chart” on page 30.
Refer to Figure 12
24. Once machine is pre-leveled, raise and lower the gangs
completely to cycle and purge air from these cylinders
.
Figure 10
5313-5315 Wing Adjustment
42061
2
2
1
2
1
2
Figure 11
5317-5323 Wing Adjustment
41729
1
3
2
1
2
3
3
Figure 12
Gang Cylinder Purging
41729
1
1