Buster bar – Great Plains TC5319 (S/N A1420X+) Operator Manual User Manual
Page 29
Great Plains Manufacturing, Inc.
Operating Instructions
25
03/06/2014
566-224M
Buster Bar
Refer to Figure 21
17. The buster bar attachment is designed to knock the tops of
the ridges and to help fill the valleys behind the chisel
shanks. The down pressure can be set by the 1/2” bolt
under the arm. To adjust the pressure, loosen the jam nut
on the back side and then adjust the 1/2” bolt. To increase
down pressure, loosen the bolt. In some instances, espe-
cially when you are running the chisel very deep, the bolt
head will not be in contact with the ball joint when the unit
is out of the ground. Once the unit is lowered into the
ground, the bolt head will come in contact with the ball
joint and pressure will be applied. Once the proper tension
is set, retighten the jam nut. There are no other adjust-
ments to this attachment.
Figure 21
Buster Bar Settings
41989
- TC5323 (S/N A1420X+) Operator Manual TC5321 (S/N A1420X+) Operator Manual TC5317 (S/N A1420X+) Operator Manual TC5315 (S/N A1420X+) Operator Manual TC5313 (S/N A1420X+) Operator Manual TC5115 (S/N A1420X+) Operator Manual TC5113 (S/N A1420X+) Operator Manual TC5111 (S/N A1420X+) Operator Manual TC5109 (S/N A1420X+) Operator Manual