Great Plains NTA2007HD Installation Instructions - Manual (Page 2)

2 2014+ Single Fold Marker Front Parts Great Plains Mfg., Inc.
113-921M Front Parts 2013-10-16
Before You Start
Compatibility
Refer to Figure 2
1.
Check the model number of the air drill against the
list at the top of page 1 to ensure it is a compatible
model. For example, this kit is not compatible with
the NTA2000 integrated air drill (which uses a
different marker kit).
Sequence
The mechanical installation may be performed on a
disconnected implement, but testing of the system
requires the complete air drill.
If installing the markers as part of pre-delivery or export
final assembly, defer marker installation until after
completing all items covered by manual 166-283Q or
166-372Q.
Inventory
2. Make sure all parts are present.
Note: Some parts are provided in left- and right-hand
versions with different part numbers. These are
not interchangeable and must be installed on the
implement side specified.
Comprehension
3. Review these instructions. Make sure the installers
understand where each part or assembly is
installed, and what tools are required for the task.
Pinch / Crush Hazards:
Remove strapping only as instructed. The marker arms are
largely pre-assembled, and held closed by strapping.
Premature removal creates pinch hazards and makes the
assemblies more hazardous to move and position.
Note: Skipped Steps:
Due to continuing manufacturing enhancements,
your kit may be more completely pre-assembled
than assumed by these instructions. Skip any
steps that are already completed.
Figure 2
NT607/2007 Serial Number Plate
31174
Figure 3
Markers on Pallet
31361