Great Plains EWD13 4109R+ Operator Manual - Manual (Page 14)

4/3/95 2-2
175-083M-A
END WHEEL STEP ASSEMBLY INSTRUCTIONS
1. Start the bolts on each end of the step weldment (#1)
to the drill (#2) using 3/4" x 2" long bolts (#3), 3/4" lock
washers (#4), and 3/4" SAE flat washers (#5).
NOTE: DO NOT tighten hardware until final assembly.
2. Bolt the step hanger weldment (#6) to the center
mount (#7) on the drill box (#2) using 1/2" x 1 1/4" long hex
bolts (#8), 1/2" lock washers (#9), and 1/2" hex nuts (#10).
Bolt the lower part of the step hanger to the front leg of the
step using the same 1/2" hardware.
3. Tighten ALL hardware when assembly is complete.
4. Mount the Slow Moving Decal (#11) to the step
hanger using 1/4" x 5/8" long round head screws (#12),
1/4" lock washers (#13), and 1/4" hex nuts (#14).
Step Assembly Instructions Drawing
Fig. 2
For the following assembly instructions, refer to Fig. 2 below.
10239