Great Plains EWD13 4109R+ Operator Manual - Manual (Page 31)

4/3/95 7-1
175-083M-A
PRESS WHEEL DEPTH ADJUSTMENT
The depth of each opener can be adjusted by the position
of the press wheel, Fig. 16. You can adjust your press
wheels up or down to achieve the correct seeding depth.
With the drill level and openers lowered to planting posi-
tion, adjust the knob and adjustment trunnion located
above each press wheel. This will vary the height of the
press wheel which automatically changes the seeding
depth of the opener. Simply rotate the knob until the seed-
ing depth is correct.
Opener Press Wheel Depth Adjustment
Fig. 16
11190
The camber angle of the 2" x 13" double "V" press wheels
may be adjusted by removing the angle bar adjustment
pin and moving the angle bar. Moving the angle bar for- ward will cause the press wheels to pull more soil over the
seed, Fig. 17. Moving the angle bar back will cause the
press wheel to pull less soil over the seed, Fig. 18.
PRESS WHEEL ANGLE ADJUSTMENT {2 x 13 DOUBLE “V” PRESS WHEELS ONLY}
Forward Position
Fig. 17
Rear Position
Fig. 18
11544 10074