Caution – Great Plains EWD13 4109R+ Operator Manual User Manual

Page 7

Advertising
background image

4/3/95

1-1

175-083M-A

SAFETY RULES

!

!

The safe operation of machinery is a big concern to farmers and manufacturers. We have designed
our End Wheel Drill with many built-in safety features. However, no one should operate this drill
before carefully reading this Owner’s Manual.

1.

NEVER permit anyone to ride on or walk beside the drill when moving.

2.

NEVER permit anyone to ride on tractor when the drill is being moved.

3.

NEVER allow anyone to be near the drill when performing operating functions with the drill or
tractor.

4.

DO NOT allow anyone to operate the Drill who has not been properly trained in its safe opera-
tion.

5.

ALWAYS fasten the drill hitch securely to the tractor drawbar with a safety lock type pin & fas-
ten safety chain securely to tractor.

6.

NEVER load the drill without being hooked up to a tractor

7.

NEVER exceed 20 MPH when transporting.

8.

Extra care should be taken when transporting with seed in the boxes.

9.

Reduce speed of the tractor when transporting over uneven or rough terrain. Avoid all chuck
holes and washboard areas in roads.

10. Reduce speed of the tractor when transporting over hills or steep slopes.

11. When in transport, use accessory lights and devices for adequate warning to operators of other

vehicles and use safety hitch chain. Comply with all Federal, State and Local laws when trav-
eling on public roads.

12. Use "Slow Moving Vehicle" emblem for warning vehicles approaching from the rear.

13. When transporting, remember the drill is wider than your tractor and extreme care must be tak-

en to allow for safe clearance.

14. NEVER back up when openers are in the ground.

15. ALWAYS set the drill in field position BEFORE lubrication, making adjustments, or servicing.

16. DO NOT lubricate, adjust or repair the drill while it is in operation.

17. DO NOT permit smoking, sparks, or an open flame where combustible lubricants or liquids are

being used.

18. When using treated seed, avoid direct contact with the seed.

19. When using compressed air to clean the drill, wear safety glasses.

20. NEVER unhook drill from tractor when negative tongue weight is present.

CAUTION!

Escaping fluid under pressure can have sufficient force to penetrate the

skin. Check all hydraulic lines and hoses BEFORE applying pressure. Fluid escaping from
a very small hole can be almost invisible. Use paper or cardboard, NOT BODY PARTS, to
check for suspected leaks. If injured, seek medical assistance from a doctor that is familiar
with this type of injury. Foreign fluids in the tissue must be surgically removed within a few
hours or gangrene will result.

!

Advertising