Great Plains 2525F Operator Manual - Manual (Page 25)

Operating Instructions 21
01/23/2012 118-232M
Parking
Empty seed box before unhitching drill to prevent drill
from falling backward.
Note: For parking with drill attached to an auxiliary hitch,
refer to your hitch operator’s manual.
1. Empty seed box.
Model 20F Only:
Refer to Figure 18
2.
Raise drill.
3. Remove pin from mount and remove parking
stand from storage position.
4. Insert stand into bottom of mount as shown in
Figure 18 and secure with pin .
5. Repeat for stand on other side of drill.
All Models:
6. Park drill on a level, solid surface.
7. Lower tractor three-point hitch until drill is on the
ground.
8. Extend or retract the top link of the tractor until top
three-point pin is free. Remove pin.
9. Remove pins from lower links.
Storage
Store the drill where children do not play. If possible,
store the drill inside for longer life.
1. Unload seed box:
• Place tarp under drill or a bucket under each row
unit.
• Use a large bucket to empty box as much as pos-
sible. Make sure seed cup door handles are set to
clean-out.
2. Thoroughly clean seed and seed-treatment residue
from boxes and seed cups.
3. Plug or cap the bottom end of seed tubes to prevent
pest entry.
4. Remove any dirt and debris that can hold moisture
and cause corrosion.
5. Lubricate and adjust all chains.
6. Lubricate areas noted under “Lubrication” on page
54.
7. Inspect drill for worn or damaged parts. Make repairs
and service during the off season.
8. Use paint to cover scratches, chips and worn areas
on the drill to protect the metal.
9. Cover with a tarp if stored outside.
FigureSpacer
Figure 18
Model 20F Parking Stand
26221
3
1
2
1 2
3
3 2
1