Great Plains DVN8324 Operator Manual - Manual (Page 31)

Great Plains Manufacturing, Inc. Operating Instructions 27
11/25/2013 550-466M
16. Insert key into tractor and restart the tractor.
Equipment Damage Risk:
Raise before unfolding. If this operation is not performed, the
wing shanks contact the ground, drag, and may be damaged.
Unfolding: Unfold Wings (page 24)
17. Unfold the wings by extending the fold cylinders.
Note: One wing may reach the ground before the other. It is
not uncommon for the folding to be slightly -non-
symmetrical.
Refer to Figure 19
Hold the circuit at extended for several seconds after the
wings engage wing stops on center frame.
Lift: Verify Transport Lock
Refer to Figure 20
Crush/Pinch Hazards:
Make sure the transport locks
are engaged. Lift and re-lower
if it is not. If the transport locks are not installed, install trans-
port locks, in the transport position the implement will slowly
lower after hydraulic power is removed. If anyone is working
on or under the implement, this could result in serious injury or
death.
Figure 19
Wing Unfold Progression
42200
1
Figure 20
Lift Lock Engaged
42185
1